Victron BlueSolar PWM Charge controller LCD-USB 48V/30A
Vat Calculated at Checkout
R1,399.00 excl VAT
Liquid crystal display
For status monitoring and set-up
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
|Dimensions||10.0 × 11.3 × 4.0 cm|
|Rated charge current:||
|Automatic load disconnect:||
|Maximum solar voltage:||
< 10 mA
Manual control + low voltage disconnect +timer
Battery reverse polarity (fuse)
Shut down after 60 s in case of 130% load
|Operating temp. range:||
-35 to +60°C (full load)
Product Data Sheet
Office: (044) 692 0229
9 Via Appie Street, Voorbaai, Mossel Bay
Product Enquiry Form
Omega Watt Approved Support
We are the approved installer and technical support agent for the following products along the Garden Route.
Please get in touch and let us know on which product that you require further support.